|
Home: How to Craft Doll DressesTo make sure that you accomplish quality doll dresses, you will need the right equipment and tools. You will need a sewing machine, cleansers, universal needles, including stretch needles, pins, olfaa panel, and a rotary or gyratory cutter. You will also need hand-sew needles, dressmaker scissors, sewing scissors, fabric glue and pen, greaseproof paper for tracing, pencil, measuring tape, lace, ribbons, fasteners, elastic, paper scissors, etc. Before you get started, you will need to clean your sewing machine. Use "Dust Away," to spray your machine near the bobbin region. You will also need to clean the bar where the needles are installed, as well as the "tension" discs at the top. Once you clear the machine of dust, use a drop of oil. Now you are prepared to make doll dresses. Before I forget, make sure you have thread, specifically DMC broder if you intend to make French dresses. How to trim: You can use the pin tuck method to trim your doll dress. You will need twin needles, and a foot that is designed for pin tucking. Set up your machine. The right needle should be clockwise while the left counterclockwise. At the "tension" discs, you should have the left needle threaded on the same side, and the right needle threaded on the right thread. To keep your dresses fresh, you can use starch to spray your dress prior to pin tucking. How to pin tuck skirts: When pin tucking skirts make sure you leave some space. How to pin tuck sleeves and/or bodice: Take a square of your fabric and pin tuck it. You can cut out the upper section of the dress and/or sleeves after. Keep in mind when you start pin tucking for sleeves and bodice, the fabric size is modified, or reduced. If you are not familiar with pin tucks, you can tuck your doll dress. To tuck you merely consider the size and width of your garment. To start you press down, pressing the folded center. Along the fold and edge of your fabric, stitch the width precisely. As long as you stay consistent within your stitching lines, you will do fine. You should always start sewing at the grain after pulling a single thread. After you complete your dress, or near the finish, you may want to consider bows, tassels, smock, or hand sewn objects. Hand embroidering is ideally used in finishing. Use a range of DMC embroidery to make finish your dress. Smocking is the added finishing whereas you use patterns to complete your dress. Silk ribbons, satin single and double ribbons make up a great pinafore, or back dressing. Tassels are easy to make, yet you will, need crochet threads and/or embroidery thread to complete your mission. You will also need cardboard in which you will need to cut out a part a length longer than your tassel. Use your thread, wound it around the cut part, and continue until you have achieved the thickness you desire. At one end of the part, use the same thread and channel it through the thickness. Next, tie the thread so that it knots and at the opposite end of your part, cut. Do not cut your thread. Now you are ready to make your tassel. To finish, at the knotted region, convey your thread so that it meets with your tassel. Next, wound another part of thread about the finish of your tassel a few times. Knot the area so that it is taut. At the finish of your tassel, skid the thread in to fasten your finished work. If the finish necessitate cutting to make sure it is constant, do so now.
|
